Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Access Control Across Keller
Gate access control in Keller means keypads, phone entry, card readers, and video intercoms wired and programmed so the gate opens when it should and stays closed when it shouldn’t. A typical keypad entry repair in Keller runs $185-$340, while a full keypad-plus-operator replacement on a swing gate usually lands between $1,400 and $2,900. We serve every neighborhood in Keller from Hidden Lakes to Marshall Ridge to the older lots along Bear Creek Parkway. A live person answers when you call (817) 562-7979, day or night.
Why Ironworks Gate Co. Is Keller’s Preferred Gate Access Control Company
We’ve worked on gates in Keller long enough to know that this town sits on a county line, and that changes how the work gets done. Keller straddles the Harris County / Tarrant County line, and low-voltage gate wiring plus post footings can be interpreted differently depending on which side of that line your property falls on. That’s not a detail a general contractor from Fort Worth always catches. We do, because we’ve pulled permits and passed inspections on both sides of the line for years.
Keller homeowners tend to stay put. They want a gate that works on the first repair, and they don’t want to explain the problem twice. Our technicians arrive in uniformed shirts, background-checked, and they work the way they’d work on their own mother’s driveway. When a Keller customer tells us the keypad went dead after the last big storm, we know to check the conduit at the hinge post before we touch a single button. That local knowledge is the difference between a fix that lasts and a part swapped out on a guess.
Victor Salinas, who leads Ironworks Gate Co., built the company around a simple promise: if it’s not right, we come back and make it right. Every job, including gate access control in Keller, carries our 90-Day Done Right Promise in writing. No paperwork, no arguing.
Our Gate Access Control Services in Keller
Keypad Entry
Keypad entry is the workhorse of Gate Access Control for Keller homes. Most of the keypads we service here are Viking, Ghost Controls, or DoorKing units mounted at the driveway edge. In Keller specifically, we see more keypad failures from hard water mineral buildup than from anything else. Irrigation overspray near the Keller Sports Park and along Johnson Road carries calcium and lime into the button contacts, and over time the keys stop registering. When we replace a keypad, we seal the new unit against that same water exposure so the replacement outlasts the original. A new keypad install in Keller typically runs $240-$480, depending on whether we’re pulling new wire or reusing the existing run.
Remote Control
Remote control access is standard on most Keller driveway gates, and the failure points are predictable: tired batteries in the transmitter, a receiver that’s drifted off frequency, or an operator board that stopped listening. We program remotes for LiftMaster, Linear, Viking, and Ghost Controls operators, and we keep common remotes and receivers on the truck so a Keller service call usually ends the same day. If your remote stopped working after a power surge from a Keller thunderstorm, the receiver is the likely culprit, not the remote itself. Most remote control fixes in Keller fall between $120 and $260.
Phone Entry
Phone entry systems let a gate call your cell phone or house line when a visitor presses the call button, and they’re growing in Keller because they remove the need to hand out a keypad code to every delivery driver. We install and service phone entry modules on Viking, DoorKing, and Elite operators throughout Keller, including on the larger estate lots in Marshall Ridge and the gated sections off Rapp Road. A phone entry add-on runs $450-$900 in Keller, assuming the operator board has an open accessory port. If the board is too old, we’ll tell you before we sell you anything.
Card Reader
Card reader access is less common on single-family Keller driveways, but we do install them for homeowners who want a fob on the visor instead of a code to remember. The readers we fit are weather-rated for Texas sun and the freeze-thaw cycles we get every Keller winter. A basic card reader tied into an existing operator runs $380-$620 in Keller. We also service the readers on the older gated communities along Keller Hicks Road, where HOA boards sometimes need a second opinion on what’s actually broken before spending association money.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Keller
We’re trained and equipped on nine gate-automation brands, so when you call about a Viking keypad or a DoorKing board in Keller, we don’t have to learn on your driveway. The brands we work on most often in Keller are Viking, Ghost Controls, and DoorKing, plus Elite on the larger estate gates. Because we stock common replacement parts for these brands and coordinate dispatch from our Dallas-Fort Worth office, most Keller jobs finish in a single visit. If a part has to be ordered, we’ll tell you that on the phone before a truck ever rolls, so you’re not paying for a diagnostic trip that ends in a shrug.
Common Gate Access Control Problems We See in Keller Homes
- Hard water mineral buildup in keypad buttons. Keller’s water is hard, and irrigation overspray near the Keller Sports Park and along Elm Street puts extra minerals onto the keypad face. Buttons stop registering, and the fix is a sealed replacement keypad, not a cleaning. We see this several times a month.
- Loop detectors knocked out of calibration by clay soil movement. Keller sits on expansive clay. Freeze-thaw cycles move the ground under slide gates, which shifts the loop detector field and makes the gate reverse or refuse to close. Recalibration is a 30-minute fix, but only if the technician knows to look for it. We do.
- Solar gates underperforming on north-facing, oak-shaded lots. Mature post oaks are part of what makes Keller look like Keller. They also shade solar panels on north-facing gate installations, which starves the battery and kills phone entry systems. We often recommend a hardwired power run or a relocated panel for these lots.
- Dead keypads after storms with corroded hinge post conduit. Water gets into the conduit at the hinge post, corrosion follows, and the keypad line goes dead. It happened recently on a Viking keypad in Hidden Lakes. Our crew dug out the post footing, reran the low-voltage wire, installed a new LiftMaster operator and safety photocell, and brought the gate back to UL 325 compliance the same afternoon.
Pricing for Gate Access Control in Keller, TX
We quote every Keller job before any work starts, so the number you agree to is the number on the invoice. A keypad replacement in Keller runs $240-$480. A phone entry add-on lands between $450 and $900. A full operator and keypad replacement on a swing gate typically falls between $1,400 and $2,900, depending on whether we’re reusing the post, pulling new wire, or adding a safety photocell and loop detector. Card reader installs run $380-$620. Still, call (817) 562-7979 for an exact quote. Estimates are free, and a free second opinion on any written estimate is a standing offer.
We also keep active offers for Keller homeowners: $50 off any repair over $250, an $89 seasonal tune-up, and a 5% discount for seniors and veterans that never expires.
We Also Serve Cities Near Keller
Ironworks Gate Co. serves Gate Access Control in Keller and the surrounding communities. If you’re in Haslet, North Richland Hills, Hurst, or Haltom City, the same crews, the same 90-Day Done Right Promise, and the same live-answer phone line apply. Call (817) 562-7979 and we’ll schedule a time that works, not a four-hour window.
Serving Keller, TX - Our Local Coverage Area
We’re based in the Keller area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Access Control in Keller
Most gate operator and keypad installs in Keller require a permit because low-voltage wiring and post footings fall under local building codes, and Keller sits on the Harris County / Tarrant County line, where permit interpretations can differ by side of the line. We handle the permit application as part of the job and confirm which county jurisdiction applies before we dig or pull wire, so your install isn’t flagged later. Call (817) 562-7979 for a free estimate that includes the permit work.
The real fix is usually the hinge post, not the keypad. When the post shifts in Keller’s clay soil, the gate sags, and the sagging gate pulls the low-voltage wire at the hinge post conduit until the connection breaks. Bolting on a new keypad won’t solve it. The correct repair is resetting or reinforcing the post, rerunning the wire, and then installing the keypad. We did exactly this on a Hidden Lakes gate where a corroded hinge post conduit had killed a Viking keypad. Call (817) 562-7979 and we’ll diagnose it before any work starts.
Yes, in most cases an existing Keller gate operator can accept a video intercom, as long as the operator board has an open accessory port and a power source is available at the gate. If the board is older and lacks a port, we’ll quote a replacement board or a standalone video intercom with its own power run. A video intercom add-on in Keller typically runs $850-$1,700 installed. Call (817) 562-7979 for a free assessment of your specific operator.
The most common cause is a loop detector knocked out of calibration by the freeze-thaw swelling of Keller’s clay soil after a rain. The expanding ground shifts the loop field, and the gate’s safety system reads it as an obstruction, so the gate reverses or refuses to close. The fix is recalibrating the loop detector or relocating it if the soil movement is severe. Call (817) 562-7979 and we’ll have a tech check it, usually within the same visit.
You should test the entrapment protection on your automatic gate in Keller once a month, following the manufacturer’s test procedure printed in the operator manual. Keller’s clay soil shifts with every rain and freeze cycle, which can gradually move the safety photocells and loop detectors out of alignment. A monthly test catches that drift before the gate fails in a way that matters. If you’d rather not do it yourself, our $89 seasonal tune-up includes a full safety check and alignment. Call (817) 562-7979 to schedule one.
Written by Victor Salinas, Owner at Ironworks Gate Co., a gate access control specialist serving Keller, TX.